Semi Automatic Water Level Controller for Start/Stop Starter Panel

Check that the mains supply to the controller is on and that the MCB has not tripped. If the supply is present and the controller still shows no lights, switch it off and contact support. Do not open the enclosure.

• Check that the AUTO/MANUAL switch (where fitted) is on AUTO.
• The level must be below the middle sensor before the motor starts.
• On models with dry-run protection (NWLC-A55, A22) the motor only starts when water is present at the source — check the corporation line or sump.
• Check that the sensor wires are connected and not broken.

If it still does not start, contact support with your model number and serial number.

• Switch off the supply to the starter at the MCB and confirm with a line tester that the power is off before touching any wiring.
• Press the starter's start button once with the power off to discharge the starting capacitor.
• Installation and servicing must be carried out by a licensed electrician.
• Never work on the controller or the pump with wet hands or while standing on a wet floor.
• Mount the controller indoors or in a weather-protected place, away from direct water spray.
• Do not open the controller or break its seal — there are no user-serviceable parts inside, and it voids the warranty.

• Water comes from the corporation (municipal) line and you want the motor protected if it runs dry: NWLC-A55.
• Overhead tank only, pump on a normal switch, MCB or electronic starter: NWLC-A11 (fully automatic, up to 2 HP).
• Pumping from an underground sump with a push-button starter panel: NWLC-A22 (fully automatic with dry-run protection, up to 5 HP).
• You want to start the pump yourself and only need an automatic stop when the tank is full: NWLC-A33 (start/stop starter panel, up to 5 HP) or NWLC-A44 (start/stop buttons on the controller, up to 2 HP).

Use the Compare page to see them side by side, or ask us on WhatsApp.

On the NWLC-A55, a dry-run sensor is fitted on the corporation (municipal) water supply line. If no water is coming, the controller switches the motor off within 60–80 seconds instead of letting it run dry, and starts it again when water is available or the power is restarted.

A fully automatic controller (NWLC-A55, A11, A22) starts the motor when the tank level drops and stops it when the tank is full — nobody needs to press anything. A semi automatic controller (NWLC-A33, A44) stops the motor automatically when the tank is full, but you press start yourself.

Check your motor's HP rating against the model: NWLC-A11 and A44 go up to 2 HP; A55, A22 and A33 up to 5 HP. Each model's page lists the starter panels it suits. If you are unsure, send us a photo of your starter panel and the motor rating plate on WhatsApp before ordering.

Yes. The controller connects to mains voltage and to your pump's starter, so it must be installed by a licensed electrician following the installation guide for your model.

Every model carries a 1-year warranty. Go to Support → Register warranty and enter the serial number on the controller with your purchase details. You will receive a registration number to quote for any service request. Keep the seal intact: there is no warranty if it is broken.